Описание штатной системы для машин c датчиком срабатывания
ETACS-ECU FUNCTIONS AND CONTROLS Mitsubishi Eclipse Cross. Vehicles with security alarm sensor M254570030048500ENG
OPERATION
1. Locks the doors by the keyless entry transmitter or keyless operation key (except for operating the door lock with the key cylinder).
2. "Ready to be armed" is set, the "Ping" tone sounds and the security indicator starts blinking. (The security alarm sensor is not disabled temporally*1.)
3. After 20 seconds, the status shifts to "Ready to be triggered".
4. Irregular door opening or tailgate opening (opening of door or tailgate without unlocking using the keyless entry transmitter or keyless operation key)
5. After the transferring to the "Warning" status, the ETACS-ECU generates the "Beep" tone, the hazard warning lamp flashes, and the security alarm siren sounds intermittently (Maximum 10 times) for 27 seconds.
With the "Ready to be triggered" status, the following operation or status immediately transfers the status to "Warning".
Open the hood.
Abnormality in ETACS-ECU power supply
Abnormality in communication and power supply of the security alarm siren
Note *1: When turning the ignition switch to the "OFF" position and the windshield mist switch to ON for 5 seconds or longer (operate the wiper lever upward), the buzzer incorporated in the combination meter sounds twice and the security alarm sensor is disabled until the ignition switch is turned to the ACC or ON position. To reactivate the security alarm sensor, turn the windshield mist switch to ON for 5 seconds or longer (operate the wiper lever upward). When the security alarm is activated, the buzzer incorporated in the combination meter sounds once.
ALARM HISTORY OUTPUT FUNCTION
If the exterior protection is activated between the last OFF operation and the next ON operation of the ignition switch, this function informs the driver by flashing the security alarm indicator and by the buzzer.