Просмотр полной версии : Подрулевые переключатели Mitsubishi Outlander XL, Citroen C-Crosser и Peugeot 4007. Переключатель указателей поворотов. Переключатель стеклоочистителя
Всем привет.
Проверил вчера, кнопка работает, но на ее нужно как то очень сильно надавливать. Так же работает при переключении режимов работы освещения.
Кто то разбирал переключатель? Сложно? Или у кого в запасе валяется? Готов рассмотреть вариант с приобретением.
Зада вопрос тут.
Можно ли не снимая руля и этой "стрекозы" заменить левый переключатель, который поворотники включает?
megaaxel
29.09.2017, 13:54
Можно ли не снимая руля и этой "стрекозы" заменить левый переключатель, который поворотники включает?
да конечно, надо только кожух снять (болтик снизу).
COLUMN SWITCH REMOVAL AND INSTALLATION M154310070022201ENG (http://mmc-manuals.ru/manuals/outlander_xl/online/Service_Manual/2010/54/html/M154310070022201ENG.HTM)
39147
WIPER/WASHER SWITCH CONTINUITY CHECK ==> M154310170009800ENG (http://mmc-manuals.ru/manuals/outlander_xl/online/Service_Manual/2010/54/html/M154310170009800ENG.HTM)
<VEHICLES WITHOUT LIGHTING CONTROL SENSOR>
39148
Switch position
Tester connection
Specified condition
OFF
-
Open circuit
Windshield intermittent wiper interval adjusting knob
6 - 3
Operating the adjusting knob changes the resistance.
Rear wiper switch
6 - 4
Continuity exists (2 Ω or less)
Rear washer switch
6 - 5
Continuity exists (2 Ω or less)
Windshield washer switch
6 - 7
Continuity exists (2 Ω or less)
Windshield wiper switch Hi
6 - 8
Continuity exists (2 Ω or less)
Windshield wiper switch Lo
6 - 9
Continuity exists (2 Ω or less)
Windshield wiper switch Int
6 - 10
Continuity exists (2 Ω or less)
Windshield wiper switch Mist
6 - 11
Continuity exists (2 Ω or less)
<VEHICLES WITH LIGHTING CONTROL SENSOR>
39149
Switch position
Tester connection
Specified condition
OFF
-
Open circuit
Windshield intermittent wiper interval adjusting knob
6 - 3
Operating the adjusting knob changes the resistance.
Rear wiper switch
6 - 4
Continuity exists (2 Ω or less)
Rear washer switch
6 - 5
Continuity exists (2 Ω or less)
Windshield washer switch
6 - 7
Continuity exists (2 Ω or less)
Windshield wiper switch Hi
6 - 8
Continuity exists (2 Ω or less)
Windshield wiper switch Lo
6 - 9
Continuity exists (2 Ω or less)
Windshield wiper switch Auto
6 - 10
Continuity exists (2 Ω or less)
Windshield wiper switch Mist
6 - 11
Continuity exists (2 Ω or less)
COLUMN SWITCH (SWITCH BODY PART) CONTINUITY CHECK ==> M154310100010700ENG (http://mmc-manuals.ru/manuals/outlander_xl/online/Service_Manual/2010/54/html/M154310100010700ENG.HTM)
1. Remove the lighting switch and wiper/washer switch.
2. Check that the continuity is present for the same terminal numbers (No. 3-11) of the column switch body connectors that remain on the steering column.
39150
Column switch body
Terminal number
Normal condition
Lighting switch side connector
Wiper/washer switch side connector
3 - 3
4 - 4
5 - 5
6 - 6
7 - 7
8 - 8
9 - 9
10 - 10
11 - 11
Continuity exists (2 Ω or less)
Diagnosis code
B2350 Lighting switch mulfunction
B2351 Wiper/washer switch mulfunction
TROUBLE JUDGEMENT
The ETACS-ECU receives the signals related to lighting and wiper/washer from the column switch. If the fail information data is included in the signal from column switch, the diagnosis code No. B2350 (lighting switch) or B2351 (wiper/washer switch) is stored.
COMMENTS ON TROUBLE SYMPTOM
The lighting switch, wiper/washer switch or the ETACS-ECU may have a problem.
PROBABLE CAUSES
Malfunction of lighting switch (with built-in column-ECU)
Malfunction of wiper/washer switch
Malfunction of the ETACS-ECU
DIAGNOSIS PROCEDURE ==> M154310050028400ENG (http://mmc-manuals.ru/manuals/outlander_xl/online/Service_Manual/2010/54/html/M154310050028400ENG.HTM)
да конечно, надо только кожух снять (болтик снизу).
Если память не изменяет: снять кожух рулевой колонки - верхний и нижний, отсоединить жгут проводки, сам переключатель по салазкам ходит - отщелкнуть 2 фиксатора и сдвинуть переключатель
Всем привет
Заменил переключатель, все встало на свои места. Работает теперь как положено.
Итого затратил: 4000 проводка +643 блок, 1500 переключатель.
Ymka,
так ты еще и ЕТАКС менял ;)
Что в итоге неисправно было?
Переключатель был не исправен.
Предыдущий хозяин вытащил предохранитель №6, омыватель фар не работал вообще, поэтому я и не знал, что он так "работает" :)
ЕТАКС заменили с Бекасом.
Теперь буду пытаться разобраться с кнопкой открывания зеркал, она у меня не работает.
Зеркала открываются и закрываются если открывать/закрывать с пульта сигналки, если успеваешь открыть дверь до открытия зеркал, то они вообще не открываются.
Иногда зеркала открываются при троекратном нажатии кнопки "открыть" на брелоке с ключом.
Если закрывать авто с штатного брелока, то зеркала не закрываются.
Для зеркал выставили кодинг "без автоматики/выключен" (вроде так)
Может есть мысли у кого такие? сига starline
Powered by vBulletin® Version 4.1.8 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved. Перевод: zCarot